Author name: Jeff Toycen

We were presented with a bit of a challenge — A couple of 10 mm ball endmills, not sure of […]

  The above pictures and Movie  Step drill created on a Journeyman JXT ================================================================== Next, we have a Step drill

Created in the early 1970s  the 16.75-inch long spindle tube is not as useful as it once was and I

Even though there are similarities with the old Cm03 Cuttermaster Attachment This is completely different, wider dovetails , machined from

Ends Overview JXT FLute grinding set up overview

When you come across a large tool that needs a new end this is a good way to take the

Flutes are easy, making good center cutting ends is not so easy, until now. With the new JXT its any

1. Remove screws from red plastic spacer but leave the spacer in place. The aluminum bracket may need to be

Tap sharpening Small Taps using the Cuttermaster Countersink cams set In this video we are using the 3 flute .03

Better late than never 🙂   Jeff