Machined 2000 Grit VS Lapped 2000 Grit
We tested the result with our amazing 2000 Grit resin bond diamond wheel Almost no detectable... read more
We tested the result with our amazing 2000 Grit resin bond diamond wheel Almost no detectable... read more
This Post is about Radius grinding start to finish. Beginning with tool Setting and ending grinding full ball end secondary’s... read more
A tool Setter allows for hard stop timing of the tool which is more accurate than a visual alignment read more
Journeyman, Tool and Cutter Grinding, Uncategorized
Just remove the center bolt in the middle , (in the t slot groove) Install the lever... read more
If you would like tickets to the show, send us an email IMTS 2024 Booth Number 237058 Stop in... read more
Abrasive wheel 2000 Same edge... read more
Neoprene Stroping belt coming up 🙂 Blade thinning Coming up , Platen Surface... read more
In this video we resize a shell reamer a few thousandths , and grind a non cutting pilot; At 2.187... read more
I had this nice new Long 4 Flute to Radius grind and neck. Was fun (interesting set up on the... read more
Use the bar height stop to time the horizontal flute. Use Step pin indexing pin Tilt the tool into the step... read more
In this Video we grind small corner rads on a carbide T cutter I definitely would not have tried this... read more