Tradesman 8 for 2024 New Scissors and Knives for Tradesman 8 Woodturner
All Tradesman Grinders haveĀ these mounting locations T8 Wood Turner , Tradesman Machinist, and EdgeĀ Apex, will all Mount this... read more
All Tradesman Grinders haveĀ these mounting locations T8 Wood Turner , Tradesman Machinist, and EdgeĀ Apex, will all Mount this... read more
Ā Ā Ā Ā We tested the result with our amazing 2000 Grit resin bond diamond wheel Almost no detectable... read more
This Post is about Radius grinding start to finish. Beginning with tool Setting and ending grinding full ball end secondary’s... read more
A tool Setter allows for hardĀ stop timing of the tool which is more accurate than a visual alignment read more
Journeyman, Tool and Cutter Grinding, Uncategorized
Ā Ā Just remove the center bolt in the middle , (in the t slot groove) Install the lever... read more
Ā If you would like tickets to the show, send us an email IMTS 2024 Booth Number 237058Ā Stop in... read more
Ā Ā Ā Ā Ā Ā Ā Ā Ā Ā Abrasive wheel 2000Ā Ā Ā Ā Ā Ā Same edge... read more
Neoprene Stroping belt coming up š Blade thinning Coming up , Platen Surface... read more
In this video we resize a shell reamer a few thousandths , and grind a non cutting pilot; At 2.187... read more
I had this nice new Long 4 FluteĀ to Radius grind and neck. Was fun (interesting set up on the... read more
Use the bar height stopĀ to time the horizontal flute. Use Step pin indexing pinĀ Tilt the tool into the step... read more