Author name: Jeff Toycen

This is handy,  Add  Spindle extension and the Step pin , simple and easy to use, also allows for a […]

This taper was out of the center by .0018   (a bunch)  we have quite a few of these in quarantine.

  This setup will give you a grind suitable for spot drilling or chamfering Movies to follow   How to

Set to 90 degree with a square 115 11V9C  wheel at stock height with 2 1/2-inch extension primary angle set

This Set up makes ends bulletproof.  easy to master because of the ability to position the wheel up and down.

Modern EOD Robotics (where it all started) (toycen.ca) These were Pretty cool , we were doing network video before real

  In this post we are going to show how to regrind variable pitch Endmills. Regardless of the endmill Variable

We were presented with a bit of a challenge — A couple of 10 mm ball endmills, not sure of

  The above pictures and Movie  Step drill created on a Journeyman JXT ================================================================== Next, we have a Step drill