Regrinding Ballnose Endmill and Bullnose Corner Radius on Variable Flute End Mills
We were presented with a bit of a challenge — A couple of 10 mm ball endmills, not sure of... read more
We were presented with a bit of a challenge — A couple of 10 mm ball endmills, not sure of... read more
The above pictures and Movie Step drill created on a Journeyman JXT ================================================================== Next, we have a Step drill... read more
Created in the early 1970s the 16.75-inch long spindle tube is not as useful as it once was and I... read more
Even though there are similarities with the old Cm03 Cuttermaster Attachment This is completely different, wider dovetails , machined from... read more
Ends Overview JXT FLute grinding set up overview read more
When you come across a large tool that needs a new end this is a good way to take the... read more
Flutes are easy, making good center cutting ends is not so easy, until now. With the new JXT its any... read more
1. Remove screws from red plastic spacer but leave the spacer in place. The aluminum bracket may need to be... read more
Tap sharpening Small Taps using the Cuttermaster Countersink cams set In this video we are using the 3 flute .03... read more
Better late than never 🙂 Jeff read more
This .4 wide wheel has corner radius profiles on each side and a flat area in the middle which can... read more
A A new single speed CM01 Certifed to UL for sale in the US ———————————————————————————————– Our new Air... read more