- Home
- Uncategorized
Uncategorized
- All
- Drill Sharpening
- EDGE
- End Mill Sharpening
- Grinding Wheels
- Gun Drill Sharpening
- Journeyman
- Tool and Cutter Grinding
- Tradesman
- Uncategorized
- video
- ...
Machined 2000 Grit VS Lapped 2000 Grit
Ā Ā Ā Ā We tested the result with our amazing 2000 Grit resin bond diamond wheel Almost no detectable... read more
Everything you always wanted to known about grinding Ball and Bull nose end mills on a Cuttermaster
This Post is about Radius grinding start to finish. Beginning with tool Setting and ending grinding full ball end secondary’s... read more
Height Setting for end mill end grinding
A tool Setter allows for hardĀ stop timing of the tool which is more accurate than a visual alignment read more
Journeyman, Tool and Cutter Grinding, Uncategorized
Make your HTD30 or FCG 30m CM01,JXT or CM01P a surface grinder
Ā Ā Just remove the center bolt in the middle , (in the t slot groove) Install the lever... read more
Cuttermasters This Week and Come see us in Chicago IMTS 2024 Booth Number 237058
Ā If you would like tickets to the show, send us an email IMTS 2024 Booth Number 237058Ā Stop in... read more
Keen Knife edge 2000 grit Abrasive Machined VS 2000 grit Honed result
Ā Ā Ā Ā Ā Ā Ā Ā Ā Ā Abrasive wheel 2000Ā Ā Ā Ā Ā Ā Same edge... read more
Bladesman DC 2024 1X42
Neoprene Stroping belt coming up š Blade thinning Coming up , Platen Surface... read more
Large Shell Reamer 2.1875 Inch Resize and Create pilot
In this video we resize a shell reamer a few thousandths , and grind a non cutting pilot; At 2.187... read more
Neck Reduction Grinds
I had this nice new Long 4 FluteĀ to Radius grind and neck. Was fun (interesting set up on the... read more
Setup tips for secondary angle grinds on larger Bull nose Rads on a JXT or a CM01P
Use the bar height stopĀ to time the horizontal flute. Use Step pin indexing pinĀ Tilt the tool into the step... read more