Reamer resizing and clearence grinding on a Journeyman JXTR with a new 5C Motor Spinde
Interesting and fun project , Tune up the Motor spindle taper then ,resize a .406 to .401 […]
Scissor Sharpening for Tradesman 8 Woodturner
All Tradesman Grinders have these mounting locationsT8 Wood Turner , Tradesman Machinist, and Edge Apex, will all Mount this scissor
Machined 2000 Grit VS Lapped 2000 Grit
We tested the result with our amazing 2000 Grit resin bond diamond wheel Almost no detectable
Tradesman
Water mister systems and Ideas for belt grinders
We are going to use a similar system for the Edge Apex Please have a look at the Origin Blade
Everything you always wanted to known about grinding Ball and Bull nose end mills on a Cuttermaster
This Post is about Radius grinding and Ball end grinding.Begining with tool Setting and ending grinding full ball end secondary’s
Tool Timing for end mill end grinding
A “Tool Setter” allows for hard stop timing of the tool rotational timing in the collet which is more accurate
ER32 Manual Shank Grinding attachment for Neck Reduction grinds, tool cut off, perfect Weldon set screw flats fits on all Cuttermaster Models
THE DC MOTOR,BEING VARIABLE SPEED MAKES THIS GRINDER MORE USEFUL. DO NOT OVERLOAD THE MOTOR AT LOWER
Make your HTD30 or FCG 30m CM01,JXT or CM01P a surface grinder
Just remove the center bolt in the middle , (in the t slot groove) Install the lever
Cuttermasters whats going on
IMTS Was Fun ! 2024 CM01P MK2 Digital The Original CM01P , Movement Study Grinding a 5C Taper in
Uncategorized
Keen Knife edge 2000 grit Abrasive Machined VS 2000 grit Honed result
Abrasive wheel 2000 Same edge