![](https://cuttermasters.com/wp-content/uploads/2021/12/IMG_1741-300x225.jpg)
Sharpen Carbide Router bits , Compression bits on a JXT
This is a test set up these tools can be sharpened a variety of ways as long as the wheel... read more
This is a test set up these tools can be sharpened a variety of ways as long as the wheel... read more
This cool item allows for 15-degree indexing , (and 8 flute ends) 15-degree indexing is hand when grinding secondary... read more
This is handy, Add Spindle extension and the Step pin , simple and easy to use, also allows for a... read more
[vc_row layout=”full”][vc_column][vc_column_text] Ends using a Tapered Cup Resin Bond Wheel [pdf-embedder url=”http://cuttermasters.com/wp-content/uploads/2021/10/2022-CM01-Ends-Tapered-Cup-Ends.pdf” title=”2022 CM01 Ends Tapered Cup Ends”] Grind ends... read more
This taper was out of the center by .0018 (a bunch) we have quite a few of these in quarantine.... read more
This setup will give you a grind suitable for spot drilling or chamfering Movies to follow How to... read more
Set to 90 degree with a square 115 11V9C wheel at stock height with 2 1/2-inch extension primary angle set... read more
This Set up makes ends bulletproof. easy to master because of the ability to position the wheel up and down.... read more
[vc_row][vc_column][vc_column_text] Resin bond wheels make small chips are weak and run hot, they need to spin fast. Usually the weapon... read more
Modern EOD Robotics (where it all started) (toycen.ca) These were Pretty cool , we were doing network video before real... read more
In this post we are going to show how to regrind variable pitch Endmills. Regardless of the endmill Variable... read more
We were presented with a bit of a challenge — A couple of 10 mm ball endmills, not sure of... read more