Edge Apex workstation updates April 2024 Front and Rear Mount for Tormek style Atachments
May 1 2024 Thinning Platen New Movie From Pete knife sharpening Well done Pete ! read more
May 1 2024 Thinning Platen New Movie From Pete knife sharpening Well done Pete ! read more
Gun Drill Sharpening, Journeyman
Step by step Positioning The 50Q sits on an Mounting plate repositioning the tower to the middle of the machine... read more
Journeyman, Tool and Cutter Grinding
Interesting and fun project , Tune up the Motor spindle taper then ,resize a .406 to .401... read more
All Tradesman Grinders have these mounting locations T8 Wood Turner , Tradesman Machinist, and Edge Apex, will all Mount this... read more
We tested the result with our amazing 2000 Grit resin bond diamond wheel Almost no detectable... read more
This Post is about Radius grinding start to finish. Beginning with tool Setting and ending grinding full ball end secondary’s... read more
A tool Setter allows for hard stop timing of the tool which is more accurate than a visual alignment read more
Journeyman, Tool and Cutter Grinding, Uncategorized
Just remove the center bolt in the middle , (in the t slot groove) Install the lever... read more
If you would like tickets to the show, send us an email IMTS 2024 Booth Number 237058 Stop in... read more
Abrasive wheel 2000 Same edge... read more
Neoprene Stroping belt coming up 🙂 Blade thinning Coming up , Platen Surface... read more