- Home
- Custom Machines – Innovative Products for Machinists and Tool Makers
- Page 2
Custom Machines - Innovative Products for Machinists and Tool Makers
- All
- Arts & Entertainment::Music
- Drill Sharpening
- End Mill Sharpening
- Journeyman
- Tradesman
- Uncategorized
- video
- ...

Grinding an inside taper – 55 RC- Cuttermaster Air Spindle Tube, 2021 Journeyman JXT
This taper was out of the center by .0018 (a bunch) we have quite a few of these in quarantine.... read more

New U3-5C How to sharpen a Spot Drill Chamfer mill, and How to grind end MIll on a U3-5C
This setup will give you a grind suitable for spot drilling or chamfering Movies to follow How to... read more

How to easily sharpen ends on a Cuttermaster, Tapered cup Wheel, Edge Grind
Set to 90 degree with a square 115 11V9C wheel at stock height with 2 1/2-inch extension primary angle set... read more

Plated 12V Rim Wheel, Center Cutting Grind ends 2, 3, 4, 5, 6 flute end mills
This Set up makes ends bulletproof. easy to master because of the ability to position the wheel up and down.... read more

Toycen Carbide Cut off New Fastcut Plated bond Diamond Wheels, Tradesman or Cuttermaster
Resin bond wheels make small chips are weak and run hot, they need to spin fast. Usually the weapon of... read more

Jeffs Other Engineering projects EOD Robots , Explosives Handling , Cool Boats
Modern EOD Robotics (where it all started) (toycen.ca) These were Pretty cool , we were doing network video before real... read more
Regrinding Variable Flute End MIlls
In this post we are going to show how to regrind variable pitch Endmills. Regardless of the endmill Variable... read more

Regrinding Ballnose Endmill and Bullnose Corner Radius on Variable Flute End Mills
We were presented with a bit of a challenge — A couple of 10 mm ball endmills, not sure of... read more

How to grind a Step Drill on a JXT or a Cuttermaster CM01 or FCG30
The above pictures and Movie Step drill created on a Journeyman JXT ================================================================== Next, we have a Step drill... read more

2021 Toycen Journeyman and Cuttermaster Air Spindle Length Options
Created in the early 1970s the 16.75-inch long spindle tube is not as useful as it once was and I... read more

CM03D Radius Attachment. Bull and Ball nose End mills, Neck reduction grinds, Weldon Flats
Even though there are similarities with the old Cm03 Cuttermaster Attachment This is completely different, wider dovetails , machined from... read more