Contact Us 
Phone 
Regrinding Ballnose Endmill and Bullnose Corner Radius on Variable Flute End Mills
We were presented with a bit of a challenge — A couple of 10 mm ball endmills, not sure of... read more
- Home
- Custom Machines – Innovative Products for Machinists and Tool Makers
- Page 3
Custom Machines - Innovative Products for Machinists and Tool Makers
- All
- Arts & Entertainment::Music
- Drill Sharpening
- End Mill Sharpening
- Journeyman
- Tradesman
- Uncategorized
- video
- ...
How to grind a Step Drill on a JXT or a Cuttermaster CM01 or FCG30
The above pictures and Movie Step drill created on a Journeyman JXT ================================================================== Next, we have a Step drill... read more
2021 Toycen Journeyman and Cuttermaster Air Spindle Length Options
Created in the early 1970s the 16.75-inch long spindle tube is not as useful as it once was and I... read more
CM03D Radius Attachment. Bull and Ball nose End mills, Neck reduction grinds, Weldon Flats
Even though there are similarities with the old Cm03 Cuttermaster Attachment This is completely different, wider dovetails , machined from... read more
JXT and CM01 Overview and Operational Slide shows
Ends Overview JXT FLute grinding set up overview read more
Cut off end mills without heat – Large HSS Tool Cut off Shorten Large reamers
When you come across a large tool that needs a new end this is a good way to take the... read more
Six Flute End Mill Center cutting 2021 Journeyman JXT (3 inch Plated bond wheel)
Flutes are easy, making good center cutting ends is not so easy, until now. With the new JXT its any... read more
Installing a DRO on your Cuttermaster or Journeyman
1. Remove screws from red plastic spacer but leave the spacer in place. The aluminum bracket may need to be... read more
Jeffs Tool grinding on a Cuttermaster How to Tips, and Set ups
Tap sharpening Small Taps using the Cuttermaster Countersink cams set In this video we are using the 3 flute .03... read more
Close Reach Mitre Rest on your favorite grinder (in case you would like 10 degrees on your (short) chisel)
Better late than never 🙂 Jeff read more
April 2021 Diamond wheel for carbide end mill corner prep, and neck reduction grinds
This .4 wide wheel has corner radius profiles on each side and a flat area in the middle which can... read more
This Week at Cuttermasters (see what Jeffs up to this week)
A A new single speed CM01 Certifed to UL for sale in the US ———————————————————————————————– Our new Air... read more