Motor Spindle for Shank Grinding (Neck Diameter Reduction, Neck Back) and Cut Off. 5C or ER32 Collet-type
Motor Spindle for Shank Grinding (Neck Diameter Reduction, Neck Back) and Cut Off. 5C or ER32 Collet-type - Image 2
Motor Spindle for Shank Grinding (Neck Diameter Reduction, Neck Back) and Cut Off. 5C or ER32 Collet-type - Image 3
Motor Spindle for Shank Grinding (Neck Diameter Reduction, Neck Back) and Cut Off. 5C or ER32 Collet-type - Image 4
Motor Spindle for Shank Grinding (Neck Diameter Reduction, Neck Back) and Cut Off. 5C or ER32 Collet-type - Image 5
Motor Spindle for Shank Grinding (Neck Diameter Reduction, Neck Back) and Cut Off. 5C or ER32 Collet-type - Image 6
Carbide cut off grinder
Motor Spindle for Shank Grinding (Neck Diameter Reduction, Neck Back) and Cut Off. 5C or ER32 Collet-type - Image 8
Motor Spindle for Shank Grinding (Neck Diameter Reduction, Neck Back) and Cut Off. 5C or ER32 Collet-type - Image 9
weldon set screw flats
Motor Spindle for Shank Grinding (Neck Diameter Reduction, Neck Back) and Cut Off. 5C or ER32 Collet-type - Image 11

Motor Spindle for Shank Grinding (Neck Diameter Reduction, Neck Back) and Cut Off. 5C or ER32 Collet-type

  • Grind neck diameter reductions / shank relief
  • Choose Collet Type: ER32 or 5C
  • Carbide tool cut off
  • Flat Weldon set screw flats
  • Save your air bearing
  • Built for our modern tool grinders and appropriate for older grinders like the MG-30, HDT-30, and CM-01 as well.
Category

$ 1,745 (USD)

  • CAD: $ 2,401
  • EUR: €1,536.77

Production grind cylinders such as end mill neck reductions and tool cut off

  • Designed for production use grinding of cylinders such as carbide and HSS end mill neck reductions and tool cut off
  • Choose 5C or ER32 collet type
  • Bolt to any table with T-slot in x or y direction
  • Plug into 110V(220) or battery-powered
  • Collets not included
  • Tailstock available ($425)

Thru-Bore

ER32 version has  3/4" thru-bore
5C version has 1" thru-bore

 

The Motor Spindle consists of an collet and spindle in a bench-mounted, honed housing. It is driven by a timing belt on a small 24 volt DC motor and is designed to be used all day.  The concentricity of the taper is less than .0005".  ER32 collets generally are available up to 3/4" but 7/8" and 1" are available as specials.  The bolt pattern allows the motor spindle to be bolted to any table with a t slot in either x or y direction.
The motorized tool spindles are built for our modern Cuttermaster Professional tool grinders but should work on just about any tool grinder with t-slots.

You may also like…

Shopping Cart
Scroll to Top