New U3-5C How to sharpen a Spot Drill Chamfer mill, and How to grind end MIll on a U3-5C
 This setup will give you a grind suitable for spot drilling or chamfering Movies to follow How to... read more
 This setup will give you a grind suitable for spot drilling or chamfering Movies to follow How to... read more
Set to 90 degree with a square 115 11V9CÂ wheel at stock height with 2 1/2-inch extension primary angle set... read more
This Set up makes ends bulletproof. easy to master because of the ability to position the wheel up and down.... read more
Resin bond wheels make small chips are weak and run hot, they need to spin fast. Usually the weapon of... read more
Modern EOD Robotics (where it all started) (toycen.ca) These were Pretty cool , we were doing network video before real... read more
In this post we are going to show how to regrind variable pitch Endmills. Regardless of the endmill Variable... read more
We were presented with a bit of a challenge — A couple of 10 mm ball endmills, not sure of... read more
The above pictures and Movie Step drill created on a Journeyman JXT ================================================================== Next, we have a Step drill... read more
Created in the early 1970s the 16.75-inch long spindle tube is not as useful as it once was and I... read more
Even though there are similarities with the old Cm03 Cuttermaster Attachment This is completely different, wider dovetails , machined from... read more
Ends Overview JXT FLute grinding set up overview read more
When you come across a large tool that needs a new end this is a good way to take the... read more